Weld buildup for aluminum die-cast molds and pin round holes (corner protrusion = burr prevention)
Reduction of finishing man-hours by 1/5! Introduction of a case where the durability of the repaired areas has improved.
Here are some examples of the use of "T-LASER." In the pin round hole area, thin burrs were occurring on the product side, which was consuming labor in the deburring process. We were performing buildup repairs with TIG welding, but there was a request to reduce the finishing labor because it was necessary to perform a large amount of buildup to improve the thin burrs and finish the product. By changing the wire size in laser welding, the amount of buildup can be adjusted to about t=0.1mm, allowing us to minimize the necessary buildup to stop the thin burrs, which significantly reduced the finishing labor. [Effects and Benefits] ■ Finishing labor was reduced to 1/5. ■ Perhaps due to the low residual stress of laser welding, the durability of the buildup repair areas improved. *For more details, please refer to the PDF document or feel free to contact us.
- 企業：テラスレーザー
- 価格：Other
